Montana REMOVER 400ml

Umweltfreundliches, ph-neutrales Abbeizspray. Es löst und entfernt Lacke schnell und zuverlässig. Bei der Anwendung entsteht eine gelartige Konsistenz, welche ein Ablaufen besonders auf senkrechten Flächen verhindert und somit einen sauberen Reinigungsvorgang gewährleistet. Der Montana REMOVER lässt sich auf Oberflächen wie z.B. Ziegel, Stein, Marmor, Asphalt, Glas, Metall oder Holz problemlos anwenden. An eisenfreien Metallen kann es zu Farbveränderungen kommen. Das Abbeizspray sollte keinesfalls auf Autos angewendet werden, da es den Lack beschädigen kann!

BROCHURE DOWNLOAD:

TECH & EFFECTS BROCHURE DOWNLOAD pdf.

What is Montana REMOVER 400ml?

Montana REMOVER 400ml is a ph-neutral, pollution free, gel-formula, lacquer removal spray that can be used to remove most types of lacquer from various substrates. It can be used to remove unwanted lacquer from surfaces as any other paint stripper.

How does Montana REMOVER 400ml spray work?

Montana REMOVER 400ml can be sprayed onto the desired surfaces. It then forms a gel-licet consistency preventing it from running off vertical surfaces. This gel dissolves and removes lacquers quickly and thoroughly. The more time it is left on, the more it will penetrate the lacquer and the substrate you are trying to remove the lacquer from.

How do I start using my Montana REMOVER 400ml can?

Remove the spray nozzle and turn the can upside down. Strike with your palm allowing safety ring to fall out. Shake vigorously for 2-3 minutes ensuring you can hear the mixing balls moving freely. Replace the cap back onto the top of the can valve and trigger away from substrate to test. If flowing freely you can start painting.

What surfaces can I use Montana REMOVER 400ml on?

Montana REMOVER 400ml can be used on walls, clay bricks, stone, concrete, marble, asphalt, glass, metal and wooden surfaces. Application on non-ferrous metals might cause discoloration. Application on soft materials like plastic can cause damage to the surface. DO NOT use on cars!

What should I observe before applying my Montana REMOVER 400ml?

It is important that the surface you will be applying the spray to is clean and free of dust, rust and oils. Sensitive areas that you do not want to apply it to should be completely covered so no REMOVER comes into contact with them. Trial on a non visible area of your substrate to avoid damage or incompatibilities. Apply outside or in a in well ventilated area when possible. We recommend wearing gloves when handling the spray.

How long should I leave the REMOVER spray on before removing it?

Apply generously and allow to act for a minimum of 10-15 minutes, depending on age and thickness of the paint you are trying to remove. Activation time can be shortened or increased up to 24 hours.

How do I remove REMOVER 400ml spray?

Scrape off with a suitable spatular type tool. If necessary wash off with a cellulose nitrate diluent or just water. Do not allow waste water to enter the waste water system. Incase of very porous surfaces, use a wire brush. Repeat these process if required.

Can I paint over Montana REMOVER 400ml spray?

It is very important to remove all traces of the REMOVAL 400ml spray before applying an further paints or coatings.